Siemens SITRANS LR560 Operating Instructions Manual page 91

3.6.2. Event Status
Event Status allows you to assign one of the status options listed below, to any
of the events listed in Event Index (3.6.1.). This allows you to tailor a device
response appropriate for your particular process. (Event Status affects
Condensed Status
Event Status Options
Good
Good: maintenance required
Good: maintenance demanded
Uncertain: maintenance demanded
* Bad: maintenance alarm
Uncertain: process related, no maintenance
Bad: process related, no maintenance
Bad: function check/local override
Good: function check
To assign a status to a particular event via the handheld programmer:
a) Go to Enable (3.5.1.) and select Yes to enable Condensed Mode.
b) Go to Event Index (3.6.1.) and enter the event index number corresponding
to a particular event.
c) Go to Event Status (3.6.2.) and choose a Status option from the table
above.
To assign a status to a particular event via SIMATIC PDM:
a) Go to Level Meter > Maintenance & Diagnostics > Condensed Status >
Enable and select Yes to enable Condensed Status Mode.
b) Go to Level Meter > Maintenance & Diagnostics > Allocation Level.
c) Select the Status line for the selected Event, then choose a Status option
from the associated pull-down menu.
3.6.3. Event Diagnosis
Allows you to assign one of the diagnostic options listed below to any of the
events listed in Event Index (3.6.1.). This allows you to tailor a device response
appropriate for your particular process.(Event Diagnosis affects Condensed
Acyclic Diagnostics and Cyclic Extended Diagnostics
Event Diagnosis Options
Status OK
Maintenance Required
Maintenance Demanded
* Maintenance alarm
Invalid process conditions
Function check or simulation
1)
Condensed Status on page 132
See
2)
Condensed Mode Diagnosis on page 136
See
7ML19985LT01 SITRANS LR560 (PROFIBUS PA) – OPERATING INSTRUCTIONS
1)
).
for more detail.
for more detail.
2)
)..
Page 85