Digital Acquisition System Specifications; Table 5: Digital Acquisition Specifications - Tektronix MDO4104 Technical Reference

Mdo4000 series mixed domain
Hide thumbs Also See for MDO4104:
Table of Contents

Advertisement

Table 4: Trigger specifications (cont.)
MIL-STD-1553
USB
Ethernet
Digital Acquisition System Specifications
Table 5: Digital acquisition specifications
Characteristic
Threshold voltage range
Digital channel timing resolution
Logic threshold accuracy
Minimum detectable pulse width,
typical
MDO4000 Series Specifications and Performance Verification
Bit Rate: 1 Mb/s
Trigger on: Sync, Word Type (Command, Status, Data), Command Word (set RT Address
(=, ≠, <, >, ≤, ≥, inside range, outside range), T/R, Sub-address/Mode, Data Word
Count/Mode Code, and Parity individually), Status Word (set RT Address ((=, ≠, <, >, ≤,
≥, inside range, outside range), Message Error, Instrumentation, Service Request Bit,
Broadcast Command Received, Busy, Subsystem Flag, Dynamic Bus Control Acceptance
(DBCA), Terminal Flag, and Parity individually) Data Word (user-specified 16-bit data value)
Error (Sync, Parity, Manchester, Non-contiguous data) Idle Time (minimum time selectable
from 4 μs to 100 μs; maximum time selectable from 12 μs to 100 μs; trigger on < minimum,
> maximum, inside range, outside range)
Data Rates Supported: HS: 480 Mbps, Full: 12 Mbps, Low: 1.5 Mbps
Trigger On: Sync, Reset, Suspend, Resume, End of Packet, Token (Address) Packet, Data
Packet, Handshake Packet, Special Packet, Error
NOTE.
HIGH SPEED support available only on MDO4104-3 and MDO4104-6 models.
Bit Rate: 10BASE-T, 10 Mbps; 100BASE-TX, 100 Mbps
Trigger On: Start Frame Delimiter (SFD), MAC Address, MAC Length/Type, IP Header, TCP
Header, TCP/IPv4/MAC Client Data, End of Packet, Idle, FCS (CRC) Error, MAC Q-Tag
control Information.
The following table shows the digital acquisition specifications for the MDO4000
Series oscilloscopes.
Description
–40 V to +40 V
2 ns main memory, 60.6 ps for MagniVu memory
±(100 mV + 3% of threshold setting after calibration)
Requires valid SPC, as described in step 2 of the Self Test. (See page 62, Self Test.)
1 ns
Using MagniVu memory. Requires the use of 342-1140-00 ground clip on each channel.
Specifications
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mdo4054Mdo4034-3Mdo4014-3

Table of Contents