Regulatory - Radcal ACCU-GOLD2 User Manual

Accu-Gold

Regulatory

EU (ETSI):
This device is intended for home and office use in all EU countries (and other countries following
the EU directive 1999/5/EC).
FCC:
Contains FCC ID: XF6-RSWC201
This device complies with the Part 15 of the FCC Rules.
(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This device and its antenna must not be co-located or operating in conjunction with
any other antenna or transmitter. To comply with FCC RF exposure compliance requirements,
this grant is applicable to only Mobile Configurations. The antennas used for this transmitter
must be installed to provide a separation distance of at least 20 cm from all persons and must
not be co-located or operating in conjunction with any other antenna or transmitter.
Industry Canada Statement:
Contains:
This device complies with RSS-210 of the Industry Canada Rules.
Japan (Telec)
Contains:
IC: 8407A-RSWC201
Telec Construction Certification Number 001-A00853.
USER GUIDE
82