Making A Measurement - Radcal ACCU-GOLD2 User Manual

Accu-Gold
clicking the Connect button may trigger a false measurement.

Making a Measurement

Note: You can make a measurement from any tab, Measure, Wave, List or Sensors.
To make a measurement:
1. Plug the sensor(s) into the digitizer module.
2. Plug the digitizer module into the USB port of the computer where you installed the Accu-Gold
software and device driver.
3. Place the sensor in the path of the X-ray beam.
4. Launch the Accu-Gold software. Select Connect via USB from the Start screen. Accu-Gold will
automatically connect and initialize the sensors. If the software is already open, click on
Connect. NOTE: Make sure the temperature of the ion chamber (if used) has stabilized before
making a measurement.
The software begins to connect to the digitizer, as indicated by the status at the bottom of the screen:
The software then begins to initialize the digitizer.
If an ion chamber is connected, the bias supply needs to start and stabilize.
USER GUIDE
17