System Start-Up - Danfoss VLT AutomationDrive FC 301 Operating Instructions Manual

Commissioning

5.8 System Start-up

The procedure in this section requires wiring and
application programming to be completed. The following
procedure is recommended after application set-up is
completed.
1. Press [Auto On].
2. Apply an external run command.
3. Adjust the speed reference throughout the speed
range.
5 5
4. Remove the external run command.
5. Check the sound and vibration levels of the
motor to ensure that the system is working as
intended.
If warnings or alarms occur, see or chapter 7.4 List of
Warnings and Alarms.
30
®
VLT AutomationDrive FC 301/302
Danfoss A/S © 07/2015 All rights reserved. MG33AQ02