Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
The installation must be performed by a qualified electrical contractor. The contractor should
take entire responsibility for the installation. The installation has to comply with the legislation
and the standards in force in your country.
How to apply the gasket:
The gasket supplied with the hob prevents the intrusion of liquids into the cabinet below.
Its installation has to be done carefully, as described below.
Fitting - installing:
Cut out sizes of the worktop:
Ensure that there is a distance of 50 mm between the hob and the wall or sides.
The hobs are classified as "Y" class for heat protection. Ideally the hob should be installed
with plenty of space on either side. There may be a wall at the rear and tall units or a wall at
one side. On the other side, however, no unit or divider must stand higher than the hob.
The piece of furniture or the support in which the hob is to be fitted, as well as the edges of
furniture, the laminate coatings and the glue used to fix them, must be able to resist
temperatures of up to 100 °C.
All surrounding areas must be adequately heat resistant.
Do not install the hob above a non-ventilated oven or any kind of dishwasher.
Ensure that the underside of the hob casing has a space of 20 mm to ensure a good air
circulation to the electronic devices.
If a drawer is placed under the hob, avoid putting into this drawer flammable objects (for
example: sprays) or non-heat-resistant objects.
Materials which are often used to make worktops expand on contact with water. To protect
the cut out edge, apply a coat of varnish or special sealant. Particular care must be given to
applying the adhesive strip supplied with the hob to prevent any leakage into the supporting
furniture. This gasket guaranties a correct seal when used in conjunction with smooth work
top surfaces.
The safety gap between the hob and the cooker hood placed above must respect the
indications of the hood manufacturer. In case of absence of instructions respect a distance of
at least 650 mm.
The connection cord should not be subjected, after installation, to any constraint, mechanical
or otherwise (for instance constraint given by a drawer installed below).
WARNING: Use only hob guards designed by the manufacturer of the cooking appliance or
indicated by the manufacturer of the appliance in the instructions for use as suitable or hob
guards incorporated in the appliance. The use of inappropriate guards can cause accidents.
Glass size
720 x 420 mm
Stick the gasket (2) two millimeters
from the external edge of the glass,
after removing the protection tape (3).
Cut-size
630 x 360 mm
17
Advertisement
Table of Contents
