Installation -
preparation
Unpacking the hob:
Take care not to lose, drop or
mishandle any parts.
Fitting position of the hob:
This appliance must be, when
installed, a minimum of 50mm
from any back wall and a minimum
of 55mm away from any adjacent
vertical surfaces, e.g. a tall cupboard
end panel. These dimensions are
shown in Fig. 8 on page 22. If
installing the hob in a cupboard unit,
then we recommend the use of a
partition panel.
Ventilation requirements:
This appliance must be installed
to allow air to flow freely to the air
intake and from the air outlet. An
air gap of 25mm is recommended
immediately below the hob. Failure to
allow sufficient ventilation could cause
problems with operation or damage
to the hob and constitutes incorrect
installation, which is not covered by
the product's warranty (Figs. 4 and 5).
20
Installation above a cupboard unit (with partition
panel) - recommended ventilation
25mm
35mm
Fig.4
Installation above an oven unit - recommended
ventilation
25mm
Fig.5
500 x 10mm
5-10mm
500 x 10mm
5-10mm