Table of Contents
Advertisement
Installation -
preparation
Unpacking the hob:
Take care not to lose, drop or
mishandle any parts.
Fitting position of the hob:
This appliance must be, when
installed, a minimum of 50mm from
any back wall and a minimum of
55mm away from any adjacent vertical
surfaces, e.g. a tall cupboard end
panel. These dimensions are shown
in Fig. 8 on page 22. If installing the
hob in a cupboard unit, then we
recommend the use of a partition
panel.
Ventilation requirements:
This appliance must be installed
to allow air to flow freely to the air
intake and from the air outlet. An
air gap of 25mm is recommended
immediately below the hob. Failure to
allow sufficient ventilation could cause
problems with operation or damage
to the hob and constitutes incorrect
installation, which is not covered by
the product's warranty (Figs. 4 and 5).
20
Installation above a cupboard unit
25mm
35mm
Fig.4
Installation above an oven unit
25mm
Fig.5
500 x 10mm
5-10mm
500 x 10mm
5-10mm
Advertisement
Table of Contents
