Gps7 Gps Synchronization And Timecode Module Remote Commands; Input Commands - Tektronix TG700 Programming Manual

GPS7 GPS Synchronization and Timecode Module
Remote Commands

INPUT Commands

Command Tree
TG700 TV Signal Generator Platform Programmer Manual
This section describes the remote commands used to control the GPS7 module
remotely. The commands to the module are divided into the following groups:
H INPUT commands
H SOURCE commands
H OUTPUT commands
H SENSE commands
H CONFIGURE commands
NOTE. Commands which control generator lock (Genlock) features are not
supported by GPS7 modules that do not have a REF IN connector.
Use these commands to control the input parameters of the module.
:INPut
:STAtus:
:REF?
:FOM? No Signal | Bad Signal | Locked
:TOD? YYYY-MM-DD HH:MM:SS
:UTC? YYYY-MM-DD HH:MM:SS
:PCOUnter?
:SIG?
:SAT?
:ANTenna?
GPS | INTERNAL | NTSC Burst | SMPTE318M |
PAL Burst | 1080 60i | 1080 59i |
1080 50i | 1080 23sF | 1080 24sF |
1080 30p | 1080 29p | 1080 25p |
1080 24p | 1080 23p |
720 50p | 720 60p | 720 59p
YYYY-MM-DD HH:MM:SS
<numeric_value>
<NR1>/<NR1>
POWER OFF | OPEN | SHORT | NOMINAL
2- 85