Sense Commands; Table 2- 4: Gps7 Output Horizontal Offset Ranges - Tektronix TG700 Programming Manual

GPS7 GPS Synchronization and Timecode Module Remote Commands

SENSE Commands

Command Tree
Command Description
2- 104
Use these commands to adjust the timing offset of the BLACK outputs relative
to the internal reference signal (frame reset signal).
:SENSe<n>
:CORRection
:MDELay
:HORizontal
:STEP
:STEP?
:FINe
:FINe?
:VERTical
:STEP
:SENSe<n>:CORRection:MDELay:HORizontal <numeric_value>
Sets the horizontal timing offset of the selected outputs. The timing
resolution is clock-cycles. The units are microseconds. If the
argument exceeds the horizontal time value, then the vertical offset
is adjusted to accommodate the requested delay. The <n> in the
command represents the output connector. "1" represents the
BLACK1 connector, "2" represents the BLACK2 connector, and "3"
represents the BLACK3 connector. See Table 2- -4 for the delay
ranges.

Table 2- 4: GPS7 Output horizontal offset ranges

Standard / Frame rate
NTSC
PAL
1080 60i
1080 59.94i
1080 50i
1080 24sF
1080 23.98sF
1080 30p
TG700 TV Signal Generator Platform Programmer Manual
1|2|3
<numeric_value> floating point
<numeric_value>
<numeric value>
<numeric_value>
<numeric_value>
Range (sample clock cycles)
¦ 3432 (54 MHz clock)
¦ 3456 (54 MHz clock)
¦ 2200 (74.25 MHz clock)
¦ 2200 (74.18 MHz clock)
¦ 2640 (74.25 MHz clock)
¦ 2750 (74.25 MHz clock)
¦ 2750 (74.18 MHz clock)
¦ 2200 (74.25 MHz clock)