THORLABS PM200 Operation Manual page 61

4 Computer Interface
Averaging Rate
Sets the averaging rate - 3000 averages take approximately 1s for performing a new
measurement value
Readout Config
Selects the measurement parameter
- POW power measurement in W
- CURR current measurement in A
- VOLT voltage measuremetn in V
- ENER energy measurement in J
- FREQ frequency / repetition rate measurement in Hz
- PDEN power density measurement in W/cm²
- EDEN energy density measurement in J/cm²
- RES thermistor resistance measurement in Ohm
- TEMP temperature measurement in °C
Stop
Stops application
Timeout [ms]
Sets a timeout value in ms that allows the instrument to sample.
The timeout must be longer than it takes to perform a new measurement. This has
especially to be considered when performing single shot energy measurements.
© 2012 Thorlabs 59