THORLABS PM200 Operation Manual page 44

PM200
Units / Display button A dialog box with the following items appears:
Logging configuration button - Opens a dialog box to:
Start/Stop log button - start and stop data logging
Reset / Clear button
Quit button
Instrument Setup Save / Recall
Long Term Measurement
42
– display resolution - set number of digits
– averaging rate, a rate of 3000 averages the incoming
measurement values for approx. 1 second
– photodiode bandwidth HI and LO
– acceleration circuit for thermal sensors ON, AUTO and
OFF
– trigger level for pyroelectric sensors
– Zeroing for photodiode and thermal sensors
Shortcut: [Shift + F3]
- configure unit of measure, depending on the connected
sensor [W, J, dBm, V and A]
- configure the left sub display
- configure the right sub display
Shortcut: [Shift + F4]
- set averaging rate for logging
- set interval between samples
- set number of samples
- configure logging into data file
Shortcut: Shift + F5
Shortcut: [Shift + F6]
- reset min/max monitor
- clear power / energy graph
- clear power / energy histogram
- clear power / energy statistics
- clear log screen
Shortcut: [Shift + F7]
- stops the PM200 application
- to restart press the white arrow in the tool bar
Shortcut: [Shift + F8]
- save / recall remote control specific parameters
Shortcut: [Shift + F9]
- sets the device to local mode between the measurement
intervals
Shortcut: [Shift + F10]
© 2012 Thorlabs