The Setup Menu; Common Settings - Imp - Interacoustics AT235 Additional Information

AT235 Additional Information Page 13

3 The Setup Menu

When holding the Setup button, a menu pops up from which you can select one of the options by rotating
the wheel and releasing the Setup button. By default, Protocol settings is selected in which you can
temporarily or permanently change the settings used during testing. Here you can also create new protocols.
In Instrument settings you can modify the license code, printer selection, time and date settings and the
brightness of the display.
In Common settings – IMP you can modify common functionalities for all impedance tests.
The Instrument protocol settings hold the default settings for when tests are added to a protocol. This is
also where you can, or example, define which reflex stimuli are used by default when adding contra reflexes
to a protocol that does not currently include contra reflexes.
In Manage protocols you can show/hide and delete protocols and set the region for factory protocols.
3.1 Common settings – IMP
For common setting imp you can toggle between Auto start (default) and Manual start. Enabling Manual
start forces the system to start each protocol paused. When Manual Start is enabled the light indicator on
the device will be flashing to indicate that the measure is paused. The measure is started by pressing Enter
or by pressing the button on the probe/shoulder box.