Siemens OH110 Technical Manual page 12

2 Safety
Safety regulations for the method of operation
12
Building Technologies
Fire Safety
Testing the product operability
Prevent the remote transmission from triggering erroneously.
l
If testing building installations or activating devices from third-party companies,
l
you must collaborate with the people appointed.
The activation of fire control installations for test purposes must not cause
l
injury to anyone or damage to the building installations. The following
instructions must be observed:
– Use the correct potential for activation; this is generally the potential of the
building installation.
– Only check controls up to the interface (relay with blocking option).
– Make sure that only the controls to be tested are activated.
Inform people before testing the alarm devices and allow for possible panic
l
responses.
Inform people about any noise or mist which may be produced.
l
Before testing the remote transmission, inform the corresponding alarm and
l
fault signal receiving stations.
Modifications to the system design and the products
Modifications to the system and to individual products may lead to faults,
malfunctioning and safety risks. Written confirmation must be obtained from
Siemens and the corresponding safety bodies for modifications or additions.
Modules and spare parts
Components and spare parts must comply with the technical specifications
l
defined by Siemens. Only use products specified or recommended by
Siemens.
Only use fuses with the specified fuse characteristics.
l
Wrong battery types and improper battery changing lead to a risk of explosion.
l
Only use the same battery type or an equivalent battery type recommended by
Siemens.
Batteries must be disposed of in an environmentally friendly manner. Observe
l
national guidelines and regulations.
Disregard of the safety regulations
Before they are delivered, Siemens products are tested to ensure they function
correctly when used properly. Siemens disclaims all liability for damage or injuries
caused by the incorrect application of the instructions or the disregard of danger
warnings contained in the documentation. This applies in particular to the following
damage:
Personal injuries or damage to property caused by improper use and incorrect
l
application
Personal injuries or damage to property caused by disregarding safety
l
instructions in the documentation or on the product
Personal injury or damage to property caused by poor maintenance or lack of
l
maintenance
A6V10316298_e_en_--
2014-05-21