Operating The Computer Control; Programming The Computer Control; Operating The Digital Control; Programming The Digital Control - Pitco 12 Installation, Operating & Service Instructions

OPERATING THE COMPUTER CONTROL:

To check the ACTUAL Temperature Press the
mode.)
To check the SET Temperature Press the
mode.)
To check the COOK, SHAKE or HOLD times press the
key. (The times will be automatically displayed in sequence, the display will return to the run mode.)
The BOIL mode will be automatically displayed when the computer senses a constant temperature of 100 ºC.
This will only happen when water is in the machine during the Weekly Cleaning process. To cancel the BOIL
mode, turn the machine off and ON again. The computer will automatically exit the BOIL mode when the oil
temperature exceeds 100 ºC.

PROGRAMMING THE COMPUTER CONTROL:

To program the SET Temperature press
To return to the COOK mode at any time press
To set COOK TIME press
to set its SHAKE TIME. Press
the COOK mode.
To enter the next level of programming press
SELECT will be displayed.
To change from ºF to ºC press
To set the PASSWORD option press
NOPASS. When a PASSWORD is required press
To set the BEEPER VOLUME press
To set the LANGUAGE option press
To set the desired MELT CYCLE option press
SOLID melt cycle options.
To view the RECOVERY TEST TIME press
To change CONTROL modes press
modes.

OPERATING THE DIGITAL CONTROL:

Press the key to turn the machine ON and OFF.
Press the key to start the Left Hand TIMER and BASKET LIFT (when installed.)
Press the key to start the Right Hand TIMER and BASKET LIFT (when installed.)
Press the key to check the ACTUAL Temperature.
P
Press the key to enter the PROGRAMMING mode.

PROGRAMMING THE DIGITAL CONTROL:

Use the and
P
Press the to enter the PROGRAMMING mode. The Left COOK TIME will be displayed, adjust as
needed. Press the
again and the SET operating temperature will be displayed, adjust as needed. Press the
the MELT CYCLE option will be displayed, adjust as needed. Press the
be displayed. The With/Without PASSWORD option may be changed. Press the
option will be displayed, adjust as needed. Press the
displayed again. To EXIT the PROGRAMMING mode press and hold the
DROP is displayed.
P
P
and a PRODUCT KEY. Enter the desired time and press
again to set its HOLD TIME. Press
1
and use
2
to display SET PASS and use
3
and use
4
and use
and use
7
keys to adjust the settings when a change is needed during the programming.
P
again and the Right COOK TIME will be displayed, adjust as needed. Press the
key (After 5 seconds the display will return to the run
key two times. (After 5 seconds the display will return to the run
key and the desired
and enter the desired Temperature.
P
P
and enter the PASSWORD (if one is set). Press
0
to toggle between the options.
P
and set the desired four digit password.
0
to toggle between the three available volume levels.
0
to toggle between the available options.
0
5
and use to toggle between the NO MELT, LIQUID &
6
0
and use again to display the recovery data.
to toggle between COMPUTER and TIMER control
0
P
key again and the Right COOK TIME will be
6
PRODUCT NUMBER
P
P P
& to return to
0
to toggle between PASREQ and
P
again and
P
key again and LOC or UNLOC will
P
key again and the ºF/ºC
P
key until MELT, HEAT or
0
and
P