Setting Sweep Range; Procedure - Agilent Technologies E4991A Operation Manual

Setting Measurement Conditions

Setting Sweep Range

Setting Sweep Range
There are two ways to set the sweep area. One is setting according to the start and stop
values, and the other is setting according to the center and span values.
Figure 3-4 Sweep Area Setting

Procedure

Step 1. Right-click to open the shortcut menu and click
Step 2. When setting the sweep area according to Start/Stop values, change the values in the
box and
values, change the values in the
Sweep Area Setting Box
Start
Stop
Center
Span
You can use any of the following methods to change the value in the box:
•
•
•
52
box in the tool bar. When setting the sweep area according to Center/Span
Stop
Right-click in the box and enter the set value by clicking the numerical and unit buttons
that appear.
Click the up or down (s or t) button to increase or decease the sweep area setting value.
After all character strings in a box have been selected (displayed in reverse), press the
keys in the ENTRY/NAVIGATION block to enter the sweep area setting value. To set
up the sweep start value of 100 MHz, for example, press
box one-by-one.
Start/Stop
box and box in tool bar.
Center Span
Input Value
Sweep start value.
Sweep stop value.
Sweep center value.
Sweep span value.
(or press ).
Start
in the
Start
Chapter 3