Electrical Length Compensation - Agilent Technologies E4991A Operation Manual

Electrical Length Compensation

The electrical lengths of the test fixtures shown in Table 4-6 have been registered in the
E4991A in advance. To use these fixtures, you may set the needed electrical length by
simply selecting the model number of the fixture to be used. If you use fixtures that are not
registered, however, you must enter the electrical length as a numerical value.
Table 4-6
Model Number
16191A
16192A
16193A
16194A
16196A
16196B
16196C
16197A
16453A
16454A (Fixture size: S)
16454A (Fixture size: L)
NOTE The 16453A is automatically selected when the permittivity measurement (
selected as material type (
The 16454A (fixture size: S) or 16454A (fixture size: L) can be selected when the
permeability measurement (
For selecting the material type, refer to "Setting Material Measurement Parameter (Option
002 only)" on page 43.
Chapter 4
Electrical Length Compensation
Test fixtures with registered electrical lengths
Electrical Length
14 mm
11 mm
14 mm
50 mm
26.2 mm
26.9 mm
27.1 mm
14 mm
0 mm
0 mm
0 mm
).
Material Type
) is selected as material type (
Permeability
Calibration and Compensation
Permittivity
).
Material Type
) is
87