Product Components And Accessories - Protimeter MMS2 Instruction Manual

Table of Contents

Advertisement

Protimeter MMS2 Instruction Manual
Do not allow children to use laser pointers unless under the supervision of
an adult.
Use only laser pointers meeting the following criteria:
Labeled with FDA certification stating "DANGER: Laser Radiation"
for Class 3R lasers or "CAUTION: Laser Radiation" for Class 2
lasers.
Classified as Class 2 or 3R according to the label. Do not use Class 3b
or Class 4 products.
Operates at a wavelength between 630 nm and 680 nm.
Has a maximum output less than 5 mW, the lower the better.

3. Product Components and Accessories

The MMS2 instrument measures the different parameters in the buildings:
room temperature, room humidity, building material moisture, surface
moisture and surface temperature (contact and non-contact method). To
measure all the above mentioned parameters, MMS2 uses different sensors,
along with a variety of accessories for convenient measurements. The
following external connections are found on the instrument (see Figure 1 on
page 3):
- This edge connection socket is for use with a Hygrostick
A
Short Quikstick probe.
- This jack connection socket is for use with a moisture probe, deep wall
B
probes or a Hammer electrode.
- This jack connection socket is for use with the Direct Contact Surface
C
Temperature Sensor.
2
®
Quikstick or
INS8800 Rev. D

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MMS2 and is the answer not in the manual?

Table of Contents

Save PDF