4.2 Pinless Moisture Meter — Selection and Use (cont.)
As reliable readings are obtained only if the sensor bulge is in direct contact
with the surface, the Search mode is not suitable for surveying textured
finishes. The nominal depth of penetration is up to19 mm (3/4") in dense,
homogeneous materials. Readings taken through low-density coverings
(carpets, polystyrene tiles, etc.) will not be representative of the moisture level
in the substrate itself. When using the MMS2 in Pinless mode, it is
recommended that no attachments are connected. This practice will minimize
reading errors and the potential for electromagnetic interference with other
electronic equipment. When the Pinless Moisture Meter mode is selected, the
device will display the surface moisture in terms of Wood Moisture
Equivalent count.
Place the MMS2 on the surface, but do not slide it. Sliding will wear
Note:
out the back of the meter, as well as possibly mark the wall.
Aquant
<60
>60 but <170
>170 but <200
>200 but <999
>999
INS8800 Rev. D
Table 2: Aquant Indicators
Display
----
Aquant value
Aquant value
Aquant value
999
Protimeter MMS2 Instruction Manual
Indication
DRY
RISK
WET
WET
Progress Bar
Green
Yellow
Red
Red
9
Need help?
Do you have a question about the MMS2 and is the answer not in the manual?