Logging - Selection And Use - Protimeter MMS2 Instruction Manual

4.6 Logging - Selection and Use

The MMS2 supports both continuous and manual logging.
4.6a Manual Logging
If is pressed at any of the measurement screens, the data and Timestamp at
that instant will be logged and a
the bottom bar.
4.6b Continuous Logging
Continuous logging is used to sample and store data continuously. Continuous
logging is enabled either by setting logging parameters through the Keypad or
through a PC using MMS2 Logging Software. (see Section 4.7g, "Set Logging
Parameters (Optional PC Logging Software Required)", on page 19.)
After the logging parameters are saved, logging starts after the
minutes have elapsed. The logging icon
corner of the screen while logging is active.
When logging is in progress, an option to stop logging is provided under the
menu. Logging can be stopped either by selecting
SETTINGS
SETTINGS -> STOP LOGGING
the MMS2 Logging Software or when the instrument is turned
INS8800 Rev. D
RECORD SAVED
in the instrument, by clicking
Protimeter MMS2 Instruction Manual
message will be displayed on
is displayed on the top right
SELECT MODE ->
STOP LOGGING
START AFTER
in
.
OFF
15