2012 Primary/Secondary Seal Head Insert Removal And Installation - SPX Votator II Instruction Manual

Maintenance
HE100-120
Figure 59 - Gland and Seat Removal
HE100-121
Figure 61 - Gland Installation
HE100-122
Figure 62 - Seal Installation
Page 58
Waukesha Cherry-Burrell
To install a new primary or secondary insert, lubricate o-rings and
the inside bore. Insert in the head with an even distribution of
force on face. Protect the face with plastic to avoid damage.
2012 Primary/Secondary Seal Head Insert Removal
and Installation
The primary seal head insert from 2012 onward has two parts, a
gland and a seat, but is removed by pushing with the special Seal
Installation/Removal tool, part number 130007+ (See Figure 60).
Figure 60 - Seal Installation/Removal Tool
The gland contains the secondary seal head insert, if present,
which is held in the primary by an O-ring. Make sure to hold the
insert or use a soft cloth to catch it to prevent it from dropping
when removed.
NOTE: To prevent damage to the seal face, do not place seal
face down on any surface during maintenance.
To install a new primary or secondary insert, lubricate all o-rings.
Use the fit of the o-ring at the top of the head bore to verify that
the inserts are correctly aligned in the bore. Make sure to align
the anti-rotation pin with the hole in the bottom of the head bore.
Insert the stainless steel gland into the head, using the 130007+
Seal Installation/Removal Tool with an even distribution of force.
Then install the secondary insert into the gland. Finally, align the
lugs on the stationary seal face with the spaces between the lugs
on the gland, and insert until it meets the gland.
95-03057
HE100-115
11/2012