Shaft Installation - Horizontal Unit - SPX Votator II Instruction Manual

Maintenance
Figure 31 - Scraper Blade Removal
Figure 32 - Drive End Head O-ring
Figure 33 - Mechanical Seal
Installation
Figure 34 - Align Shaft Splines with
Gear Reducer
Page 48
Waukesha Cherry-Burrell
11. Remove scraper blades and service as necessary. See
"Scraper Blade Maintenance" on page 45
NOTE: Blades should be kept in the same position on the
mutator shaft throughout the life of blade. Make sure blades are
removed and reinstalled in the same location on the shaft.

Shaft Installation - Horizontal Unit

1. If the drive end head has been removed, make sure the O-
ring (See Figure 32, Item A) is installed in opposite drive end
head. Lubricate lightly.
2. Install drive end head (if necessary).
3. Install mechanical seal on drive end of shaft as shown in
Figure 33. see "Mechanical Seal Maintenance" on page 56.
4. Install all scraper blades on mutator shaft.
NOTE: Blades should be kept in the same position on mutator
shaft throughout life of blade. Make sure blades are removed and
reinstalled in the same location on the shaft.
5. Place shaft in shaft removal skid.
6. Apply anti-seize compound to the drive end splines and the
next 3 inches of stub shaft length
7. Push shaft and shaft removal skid into tube as a unit. This will
ensure that tube will not be scored when shaft is replaced.
8. Push spline of shaft partially into gear reducer. Shaft may
need to be rotated slightly for splines to seat in gear reducer.
See Figure 34.
9. Lift shaft slightly to remove shaft removal skid.
95-03057 11/2012