Channeling The Cables From The Bottom Of The Box - Honeywell TemaLine TemaKey Installation Manual

Channeling the Cables from the Bottom of the Box

Channeling the Cables from the Bottom of the Box Channeling the Cables from the Bottom of the Box Channeling the Cables from the Bottom of the Box
As an alternative, you can channel the cables so that they exit from
the bottom of the frame. This alternative procedure consists of the
following steps:
1. Drill a hole in the wall so that the hole from which the cables exit is
in the center of the lower plate.
2. Break off the lower removable tab from the upper support.
3. Break off the upper and lower tab from the lower support.
4. Insert both the cables from the wall and the remainder of the cable
in the cable clamp (be careful not to pull out the screws).
5. Use the dowels to attach the frame to the wall.
6. Adjust the length of the cables so that they protrude by ~10cm
from the wall.
7. Roll up the terminators of the cables from the wall and the
extension cables, and fasten them to the cable crimps (see Figure
10).
8. Fasten the cable crimp to the contacts in the direction shown in
Figure 10.
9. Place the remainder of the cables inside the frame and lock the
cable clamps.
Figure 10: Channeling the cables from the bottom of the box
Mounting the Unit on the Wall Page 17