Connecting Procedure; Operating Procedure - Nidek Medical ARK-500A Operator's Manual

OPERATION WHEN PERIPHERAL DEVICES ARE CONNECTED: Connecting to the NIDEK Motorized Refractor (RT) or Computer
3.1.2

Connecting procedure

1
Connect the RT (or a computer) to the data output port (
communication cable (optional).
Connect the cable with the device laid down.
Attach a ferrite core (optional) to the the ARK-500A side connector of the communication
cable.
3.1.3

Operating procedure

1
After measurement, press the print button
Perform the printing process in the standard manner.
See "2.2 Preparation for Measurement" (page 20) for the measuring method.
See "2.11 Printing" (page 55) for printing.
2
The ARK-500A automatically transmits data to the RT (or computer).
When the ARK-500A is connected to the RT, it receives data No. (ID No.) from the RT.
When the ARK-500A is connected to a computer, it does not receive data No. (ID No.).
3
The measured data is printed.
When the ARK-500A is connected to the RT, the data No. (ID No.) is also printed.
78
RS-232C cable (optional)
To RT or computer
• Disconnect the communication cable while
pressing the button on the connector.
When the cable is connected, the button is
located on the underside of the connector.
Ferrite core (optional)
.
) of the ARK-500A via a
Button