Configure The Grid Profile; Build The Virtual Array - enphase M250 Installation And Operation Manual

Configure the Grid Profile

If you did not set the Grid Profile during registration or if you need to change the Grid Profile, use the
Envoy interface to configure the Grid Profile (alternate voltage and frequency trip points) for the system.
Refer to the Envoy Communications Gateway Installation and Operation Manual at
http://www.enphase.com/support

Build the Virtual Array

When the system is energised and the Envoy detects all the installed microinverters, you can create the
virtual array in Enlighten from the installation map you created. Once the virtual array is built, Enlighten
displays a graphic representation of the PV system. It also shows detailed current and historical
performance information. Go to
web-based monitoring and analysis.
To scan and upload the map and build the array:
1. Scan the installation map and upload it to the Activation form online.
2. Use Array Builder to create the virtual array in Enlighten. Use your installation map as your
reference.
NOTE: Go to
3. If you do not already have an account, go to
to register.
25
for instructions.
http://www.enphase.com
http://enphase.com/support/videos/
http://www.enphase.com
 2016 Enphase Energy. All rights reserved.
M-Series Microinverter Installation and Operation
for more information on the Enphase Enlighten
to view the Array Builder demo.
and click "Enlighten Login"
141-00024 Rev 02b