Table of Contents
Advertisement
OPC8000 series
3.1 Operating location
The control system is designed for use inside a switching cabinet. Make certain that the
specified environmental conditions are maintained at all times. Use in non-specified
environments, i.e., on board ships, in explosive atmospheres or at extreme elevations, is
prohibited.
ATTENTION
Hazard due to condensation
Damage to electronic components caused by
condensation resulting from temperature
fluctuations.
The device should only be switched on
after it has acclimated to the ambient
temperature!
To avoid overheating in operation: The
device must not be exposed to direct
radiation by sunlight or any other heat
source.
3.2 Damage due to improper use
Should the control system have evident signs of damages caused, e.g., by improper operation
or storage conditions or due to improper use or handling, the device must be shut down
immediately. Ensure that it is secured against being started up accidentally.
3.3 Warranty / repairs
During the device warranty period, any repairs must only be performed by the manufacturer or
by service personnel that has been authorised by the manufacturer.
© ADS-TEC GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen
15
Advertisement
Table of Contents
