Table of Contents
Advertisement
OPC8000 series
9 Software
The device will be delivered with a pre-installed operating system depending on what the
customer wants. The drivers required for this, are already installed and the operating system
will be enabled by entering the licence information. Should an initial installation be required,
please follow the following steps. With a newer operating system, the network card and
graphics card will properly be recognised during the initial installation, so that only the touch
screen driver and the soft keyboard must be installed separately.
Information:
If the hard drive was formatted, the operating system can be
reinstalled by using one of the existing interfaces.
An external keyboard is required for installation.
Installing the operating system
The device does not have any integrated CD drive. The installation of the operating system
can therefore only be carried out by using the USB interface.
Procedure for installation:
The boot drive in the system Bios must be switched to USB in order to boot
the device from the USB interface.
Restart the device and insert a Windows CD.
Install Windows and set up the basic data.
With devices including touch screens, the touch screen driver as well as the
soft keyboard should be installed in order to ensure their full functionality.
9.1 Configuration Center
If a pre-installed operating system is available on your device, ADS-TEC provides software
modules. These software modules are specifically designed for each device and can be
accessed in the Configuration Center.
Information:
Additional information and a detailed instruction manual for the
Configuration Center, can be found on our website.
http://www.ads-tec.de/support/download/
© ADS-TEC GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen
48
Advertisement
Table of Contents
