Connecting And Disconnecting The Spo 2 Sensor Cable - Welch Allyn 53000 Directions For Use Manual

Directions for Use
Connecting and Disconnecting the SpO
To connect the SpO2 sensor cable:
1. Locate the SpO
2. Note the hole patterns of the connector halves, and align the cable connector
accordingly.
Note
3. Carefully insert the SpO
If you are using a sensor extension cable, plug the sensor into the extension cable and
plug the extension cable into the monitor.
sensor cable connector (labeled SpO2) on the side of the monitor.
2
Verify that the sensor cable connector has slots on both sides. If the cable
connector has a slot on only one side, then the sensor is not compatible with the
monitor.
The SpO connectors are notched and flanged to ensure proper fit. If the
2
connectors do not join easily, stop and verify the following:
• You have the correct SpO
• The cable connector is aligned correctly.
cable connector into the SpO
2
Sensor Cable
2
sensor.
2
monitor connector.
2
Chapter 2 Setup 15