Welch Allyn 53000 Directions For Use Manual page 42

36 Chapter 3 Patient Monitoring
4. To select the currently displayed interval, press any button other than
Ten seconds after you select an interval, and assuming that safe venous return
pressure (SVRP) has been maintained for at least 30 seconds, the monitor starts the
first automatic NIBP cycle and the following occurs:
•
•
•
Note
When the NIBP cycle ends, a tone sounds and the monitor displays the measurement
results, including pulse rate in the
the patient, the pulse rate is derived from the SpO
16
1 0
The measurement display persists until one of the following occurs:
•
•
•
Note
The cuff inflates to the default pressure level.
The SYS window dynamically displays the current cuff pressure.
If MAP is enabled, the MAP measurement value alternates with the time display
in the message window.
If a MAP alarm occurs, the MAP is displayed steadily in the message window.
kPa
SYS SpO %
2
2
.
DIA
7
.
20:05:42
the next cycle begins, if the monitor is still in automatic NIBP mode
two minutes pass
is pressed again
If the first cycle does not produce a measurement, the monitor retries the
measurement using a target pressure calculated from the results of the previous
cycle.
Welch Allyn Vital Signs Monitor 300 Series
window. (If the SpO
sensor.)
2
/min
53
ºC ºC
, or .
sensor is attached to
2