Changing Temperature Type And Measurement Units - Welch Allyn 53000 Directions For Use Manual

Directions for Use

Changing Temperature Type and Measurement Units

Default setting: F (Fahrenheit predictive).
To change the temperature type and the temperature measurement units:
1. With the monitor on, press
window. One or two green LEDs to the right of the temperature window illuminate to
indicate the selected temperature type.
2. Press
119
3. To select the displayed units and return to normal operation, either do nothing for 10
seconds or press any button other than
as
For information on temperature measurements, see
mmHg
SYS SpO %
2
DIA
TEMP MODE
or as needed to cycle to the desired display:
F (Fahrenheit Predictive)
F M (Fahrenheit Monitored)
C (Celsius Predictive)
C M (Celsius Monitored)
mmHg
SYS SpO 2 %
DIA
79
20:30:16
), the monitor returns to normal operation with that function (
repeatedly until TEMP MODE appears in the display
/min
ºC ºC
M
/min
0
9 8 6
ºF ºF
.
or . If you press a function button (such
"Patient Monitoring"
Chapter 2 Setup 27
) activated.
on page 31.