Kalfire GP75/59F User Manual page 31

Error code Cause
The temperature
of the printed
02F
circuit board is too
06E
Communication
or
failure between
the remote control
and the fire
is flashing
Solution
Switch off the fire for around 30 minutes. Then
turn it back on. If the error code displays again,
this indicates that the ventilation in the hearth of
high. the fire is insufficient. Contact your installer.
If the indicator light on the burner control (in the
technical unit) is not flashing:
Check the voltage in your home. If the voltage is
correct, you should contact your installer in order to
detect a possible fault in the 24V transformer or the
burner control.
If the indicator light on the burner control (in the
technical unit) is flashing:
Bring the remote control as close as possible to the
fire and press
light continues to flash, resynchronise the remote
control and the technical unit (see error code
'NOLK').
. Wait for about 60 seconds. If the
31