Arctic Cat Prowler 700i HDX 2015 User Manual page 45

Clock / operating hours counter (10) – The clock is set to the 12 hour format. The
operating hours counter displays the total operating hours of the vehicle and cannot
be reset to zero.
Setting the clock:
1. Turn ignition key into position RUN and press "M" button (6) repeatedly until the
clock or the operating hours counter (10) is displayed.
2. If required, press the "S" button (7) to select the clock display.
3. To set the hour display, press and keep "S" button (7) pressed until the minute
display stops counting and the hour display shows the desired hour.
4. Release "S" button (7).
5. For setting the minute display, press the "S" button (7) repeatedly until the desired
number of minutes is displayed.
NOTE
If nothing is entered for approximately 2 seconds, the gauge will return to its
normal function.
NOTE
The time of day memory is checked and reset during start-up of the gauge.
If the power supply of the time of day memory fails (e.g. defective fuse) the
display will flash until the power supply of the time of day memory is restored.
If the display is flashing: check 15 A device fuse.
NOTE
The operating hours counter starts only after an engine speed of more than
500 rpm is reached.
ATTENTION
Permanent operation at a too high engine temperature leads to engine dam-
age and premature wear.
Differential lock indicator (11) – The LOCK indicator appears when the differential
lock is activated.
Controls 4
45