Arctic Cat Prowler 700i HDX 2015 User Manual page 42

4 Controls
Speed/revolutions indicator (12) – Depending on the selected function, it will dis-
play the approximate vehicle speed (km/h or MPH) or the engine speed.
Toggling between speed/revolutions indicator:
1. Press "S" button (8).
EFI error display - When an error occurs in the electronic fuel injection system, the
speedometer needle turns to the end stop, the entire gauge display goes out, an error
code and a wrench icon appear in the gauge display. After 30 seconds, the speed/
revolutions indicator appears again. The error code and the wrench icon will be dis-
played in the gauge display as long as the error has not been rectified.
NOTE
Have EFI errors rectified as soon as possible at an authorised Arctic Cat
specialist repair shop.
Battery status indicator – In the event of a voltage drop (< 9 V) or an overvoltage
(> 16 V) the (flashing) display "VOLT" will appear in the display.
Temperature indicator – When the engine temperature exceeds the normal operat-
ing range, the (flashing) temperature icon appears and the speedometer needle turns
to the end stop. After 30 seconds, the speedometer needle returns to the normal oper-
ation mode. The temperature icon will continue flashing until the engine has cooled
off to the normal operating range.
ATTENTION
Permanent operation at a too high engine temperature leads to engine dam-
age and premature wear.
42