Switch Assignment Table - FUTABA T8J-2.4G Instruction Manual

SWITCH ASSIGNMENT TABLE

below.
check that you have the desired switch assignment for each function during set up.
Switch/VR
A or H
SWITCH A
SWITCH B
SWITCH C
SWITCH D
SWITCH E or G*
SWITCH F or H*
SWITCH G or E*
SWITCH H or F*
VR
*On the 8JA Mode 2 transmitters, the TOP LEFT SWITCHES are spring-loaded and 2-position; on the 8JA Mode 1, 8JH, those
switches are on the right side. For consistency, the switch position's designation remains the same (upper left is F, etc), but the
functions are moved to match the switch type.
TO TURN ON THE 8J SYSTEM
First make sure the throttle stick is in the low throttle position.
*If the throttle stick is not in the low position,
you'll have an alarm until the stick is in the low position.
Airplane ( ACRO )
elevator dual rate
rudder dual rate
up = ELE-FLP on
center/down = IDLE-DOWN
down = AIRBRAKE on
aileron dual rate
landing gear/ch 5
snap roll/trainer
none
none
FLAPERON on)
AUX-CH .
Helicopter ( HELI )
elevator dual rate
rudder dual rate
governor
aileron dual rate
throttle hold/ch5
trainer/ THR-CUT
idle-up 1 and 2
idle-up3/gyro
CH8
Push up to turn on
13