FUTABA T8J-2.4G Instruction Manual page 65

LINEAR PROGRAMMABLE MIXES ( PROG.MIX1-4 ):
Adjustability:
these mixes, simply select that mix number so that the master and slave servos are already selected for you.
PROG.MIX1
PROG.MIX2
PROG.MIX3
PROG.MIX4
also be set to the master channels. (see below.)
the controlling channel. The channel whose movement is followed by the slave channel.
Another channel:
coupling.)
MASTER
RUDD AIL
To create an OFFSET
when SWITCH C is in down position.)
MASTER
OFS FLP
(Ex: create a second throttle trim on DT6 lever.)
MASTER
DT6 THR
the controlled channel. The channel that is moved automatically in response to the movement of the master
With TRIM OFF , rudder trim would bind the two servos. TRIM ON resolves this.
Your 8J contains four separate linear programmable mixes. (Note that P.Mixing
There are a variety of reasons you might want to use these mixes. A few are
setup follows, step by step, to assist you.
HELI
TRIM
ANY
OFF
TRIM
N/A
C
TRIM
N/A ANY
HELI
POSITION RATE
NULL 25%
POSITION RATE
DOWN 20%
POSITION RATE
NULL 5%
65
0
N/A
N/A