Atl - FUTABA T8J-2.4G Instruction Manual

Adjustable travel limit ( ATL
disabling the trim at high throttle. This prevents pushrod jamming due to idling trim changes. This function defaults to ON .
If you are not using channel 3 for throttle, you may want trim operation the same as on all other channels. To do so, set ATL
to OFF . If you need the ATL
that this affects all models in the radio, not just the model you are currently editing. THR-REV , see p. 92.
GOAL of EXAMPLE:
Change ATL from ON to OFF for battling
channel 3 uses.
Where next?
LCD screen adjustment ( CONTRAST / BACK-LIT / LIT-TIME / LIT-ADJS ):
GOAL of EXAMPLE:
Change CONTRAST from 0 to +2 .
TRIM LEVER (THROTTLE TRIM) effective only at low throttle,
STEPS:
Open the menu, then open PARAMETER
submenu.
Go to ATL and Change. (Ex: to OFF )
Close.
Set up ELEVON
Set up IDLE-DOWN and THR-CUT
Utilize servo REVERSE : see p. 35.
Adjust servo travel with END POINT : see p. 36.
Set up dual/triple rates and exponential( D/R , EXP ): see p. 39.
Adjustability:
The following LCD screen adjustments are possible.
STEPS:
Open the menu, then open PARAMETER
submenu.
Go to CONTRAST and change setting.
(Ex: +2 )
Close.
32
THR-REV setting. Note
INPUTS:
for 1 second.
to PARAMETER .
to ATL . to OFF .
INPUTS:
for 1 second.
to PARAMETER .
to CONTRAST .
to +2 .