Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for FUTABA T6L Sport
Summary of Contents for FUTABA T6L Sport
- Page 1 6-Channel Digital Proportional R/C System INSTRUCTION MANUAL 1M23N30302...
-
Page 2: Table Of Contents
● Mounting the receiver switch ・・・・・・・・・・・ 22 ● Safety precautions when you install receiver and servos 22 ● Change to mode1 ・・・・・・・・・・・・・・・・・ 23 ● Technical specifications ・・・・・・・・・・・・・・ 24 Technical updates and additional programming examples available at: http://www.futaba-rc.com/faq Entire Contents © 2017... -
Page 3: Introduction
R/C system. This system is extremely versatile and may be used by beginners and pros alike. the Futaba Service Center. Support and Service: It is recommended to have your Futaba equipment serviced annually during IN NORTH AMERICA information on the 6L Sport radio system and is updated regularly. Any technical updates and for the most rapid and convenient response. -
Page 4: Application, Export, And Modification
The responsible party of this device compliance is: Futaba Service Center The RBRC. SEAL on the nickel-cadmium battery contained in Futaba products convenient alternative to placing used nickel-cadmium batteries into the trash or Corporation involvement in this program is part of its commitment to protecting our environment and conserving natural resources. - Page 5 Federal Communications Commission Interference Statement (for U.S.A.) against harmful interference in a residential installation. --Reorient or relocate the receiving antenna. --Consult the dealer or your Futaba Serivce center for help. CAUTION: To assure continued FCC compliance: user's authority to operate the equipment.
-
Page 6: Definitions Of Symbols
Use of this product with other than models may be restricted by Export and Trade Control Regulations. 3. Modification, adjustment, and parts replacement Futaba is not responsible for unauthorized modification, adjustment, or replacement of parts on this product. ■ No part of this manual may be reproduced in any form without prior permission. - Page 7 ■ Near or above people. sion. Also, when using the trainer function, check the operation of both the teacher and student ■ Near homes, schools, hospitals or other places where people congregate. transmitter. ■ Near high voltage lines, high structures, or communi- ■...
- Page 8 ■ Since the metal parts of the case may corrode, always keep them clean. ■ Futaba is not responsible for damage sustained by combination with other than Futaba Genuine Parts. Use Join the Academy of Model Aeronautics. the parts specified in the instruction manual and catalog.
-
Page 9: Features
Communications System R3006SB, R3008SB, R3001SB T-FHSS Air *R304SB,R304SB-E,R314SB,R314SB-E,T-FHSS surface system receivers do not operate. NOTE： *The Futaba T-FHSS Air S-FHSS/FASST/FASSTest systems. Use T-FHSS Air *The T-FHSS Air system and T-FHSS T6L Sport cannot be used R304SB,R304SB-E,R314SB,R314SB-E or T-FHSS surface system receivers. -
Page 10: Transmitter Controls
T6L Sport Transmitter Built-in Antenna Carrying handle Monitor LED CH6 Volume CH5 Switch Throttle Elevator Stick Stick Rudder Aileron Stick Stick Throttle Elevator Trim lever Trim lever Rudder Aileron Trim lever Trim lever Hook Power Switch (for optional neckstrap) (Up position: ON) -
Page 11: Receiver R3106Gf
R3106GF Receiver The R3106GF receiver has 6 PWM channel outputs. R3106GF is T-FHSS Air system, but the Connection example telemetry function isn't equipped. LED Indication Green Status Solid No signal reception Solid Receiving signals Alternate blink Unrecoverable error (EEPROM, etc.) Receiver installation precaution Antenna installation for carbon fu- selage... -
Page 12: Installation Of The Battery
chased from a hobby shop. Check: in the case or incorrect battery polarity. Disposal of the Dry Cell Batteries: Push The method to dispose of used dry cell bat- side. Dispose of the batteries in accordance Battery Cover Slide the battery cover off the transmitter in the direction of the arrow in the figure. -
Page 13: Transmitter Power On/Off (And Fail Safe)
part of the front of a transmitter. Throttle Stick Low ON the Power Switch (F/S position) If the power switches are turned off in the opposite order the model may unexpectedly run out of control and cause a very dangerous situation. Always be sure the motor/engine is stopped. -
Page 14: Stick Control : Airplane Example
Stick control : Airplane Example A general model example. (There is also a different operational model.) Roll axis Control Pitch axis Control Right roll Nose Up The right aileron is up. Elevator stick The left aileron Aileron stick is down. To the right (moved to the bottom) Elevator is up. -
Page 15: Trim
CH3 Throttle Trim CH2 Elevator Trim the transmitter. These trims are for adjusting the neutral position of the der servos and for setting the idle r.p.m. of the en- The intended use of the trims is to make small ser- CH4 Rudder Trim CH1 Aileron Trim ◆When the airplane goes up while the... -
Page 16: Channel-5・Switch
This volume operate the servo connected to channel six in the trol used to operate them accordingly. Trainer cord (available separately) by connecting the T6L Sport-2.4GHz to the instructor’s Futaba transmitter. ally best for the instructor to hold the radio that has been setup for the plane... -
Page 17: Link Procedure
Place the transmitter and the receiver Less than 20 inches close to each other within 20 inches(half meter). To activate the Link Mode. Transmitter in "Link Mode" Transmitter LED blinking Once 1s ON - Once 1s OFF Enters the link mode for 15 seconds Turn on the power switch. -
Page 18: Power Down Mode
T6L Sport. To activate the Power Down Mode Transmitter in "Power down Mode" Transmitter LED blinking Once 0.5s ON - Once 0.5s OFF Enters the link mode for 90 seconds Operate both sticks fully in the Turn on the power switch. -
Page 19: Servo Reverse
on the model to be certain they are operating in the correct direction and that you did not crash! *Note that the direction of the aileron servo is easily mistaken. Push Battery Cover Slide the battery cover off the transmitter in the direction of the arrow in the figure. -
Page 20: Elevon Mixing
Elevator operated by a separate servo. Aileron 7th switch, the top 8th switch, the bottom combine the elevator and rudder functions. function to achieve the correct direction CH2 (CH4) CH4 (CH2) Elevator UP Elevator DOWN Rudder Right Rudder Left (Stick mode 2) 7th switch, the bottom 8th switch, the top... -
Page 21: Flaperon Mixing
The ability to use separate servos to function in the Channel 6 must be used as the additional aileron/flap Volume operation aileron stick accordingly. function to achieve the correct 2 ailerons are down in same. (Up in same) 7th switch, the top 8th switch, the top 7th switch, the bottom 8th switch, the bottom... -
Page 22: Mounting The Receiver Switch
WARNING Connecting connectors Be sure to insert the connector until it stops at the deepest point. How to protect the receiver from vibration and water Wrap the receiver with something soft such as foam rubber to avoid vibration. If there is a chance of getting wet, put the receiver in a waterproof bag or balloon to avoid water. -
Page 23: Change To Mode1
→ the stick ratchet must be changed. Technique Futaba service. MODE 1 MODE 2 Open the battery cover on the back of the transmitter and remove the transmitter battery. This part is cut Remove the four transmitter rear case screws and remove the rear case. -
Page 24: Technical Specifications
Transmitter T6L Sport Transmitting frequency: 2.4GHz band Receiver R3106GF...
Need help?
Do you have a question about the T6L Sport and is the answer not in the manual?
Questions and answers
How to adjust the end points?
How do to adjust the End Points