Device Description; Installation Instructions Compax3M; In This Chapter You Can Read About: Installation Instructions Compax3M - Parker Compax3M Installation Manual

Device description

3. Device description
3.1

Installation instructions Compax3M

24
In this chapter you can read about:
Installation instructions Compax3M
Mounting and dimensions ................................................................................................ 26
State of delivery ............................................................................................................... 28
Meaning of the status LEDs - Compax3 axis controller .................................................... 28
Meaning of the status LEDs - PSUP (mains module) ....................................................... 28
PSUP/Compax3M Connections ....................................................................................... 29
Communication interfaces ............................................................................................... 38
Signal interfaces .............................................................................................................. 41
General introductory notes
Operation of the Compax3M multi-axis combination is only possible in connection

with a PSUP (mains module).
Axis controllers are aligned at the right of the mains module.

Arrangement within the multi-axis combination sorted by power (with the same

device types according to device utilization), the axis controller with the highest
power is placed directly at the right of the mains module.
e.g. first the device type with high utilization, at the right of this, the same device
type with a lower utilization.
Max. 15 Compax3M (axis controllers) per PSUP (mains module) are permitted

(please respect the total capacity of max. 2400µF for PSUP10, max. 5000µF for
PSUP20).
The continuation of the current rail connection outside the axis combination is not

permitted and will lead to a loss of the CE and UL approbation.
External components may not be connected to the rail system.

Required tools:
Allen key M5 for fixing the devices in the control cabinet.

Crosstip screwdriver M4 for connection rails of the DC rail modules.

Crosstip screwdriver M5 for grounding screw of the device.

Flat-bladed screwdriver 0.4x2.5 / 0.6x3.5 / 1.0x4.0 for wiring and mounting of the

phoenix clamps.
192-120148N5 June 2011
.................................................................................. 24
Multi-axis devices