Parameter Setup; Multi-Variable Type Parameter (Only For /Mv); Parameters List - YOKOGAWA DY025 User Manual

5. PARAMETER SETUP

5.1 Parameter Setup
The parameters are set before factory shipment. Set the
required parameter of changing fluid, contact out and
indication of display.
5.2 Multi-Variable Type Parameter
(Only for /MV)
Parameter item F is indicated when /MV is selected.
The parameters are set before factory shipment, but it is
necessary to set the analog output of temperature, span of
temperature output.
IMPORTANT
For the remote type, be sure to set the cable length
(F52) for DYA, remote type converter, because of
effect of the cable length.

5.3 Parameters List

This section describes the parameter of digitalYEWFLO.
• Contents of parameter lists.
Item
Parameter Parameter item number.
number
Name Parameter name.
R / W Indicates parameter attributes.
(Read R : Display only (writing is not permitted).
and write) W : Writing is permitted.
Data range Shows data setting ranges for numerical value
entry.
Shows data to be selected for data selection.
( ) in parentheses, data code is shown for the
display.
Unit Engineering unit.
Remarks Remarks such as a description of the contents
are given.
Disp. D : Display can set parameter.
U / D L : Parameter can be set by UP LOAD and
DOWN LOAD.
(Check all parameters after setting by DOWN
LOAD.)
Initial value Indicates the initial set values.
5-1
5. PARAMETER SETUP
Description
T050301.EPS
IM 01F06A00-01E