Wire Hanging - Pioneer PDP 427CMX Technical Manual

PDP Bracket: PDK-5005

4.10.5 Wire hanging

Note
When hanging by wires using eyebolts (Plasma Display facing sideways), the display will tilt forward by approximately
20 degrees due to its weight distribution. Therefore, take this into consideration in advance when hanging it by
wires.
PDP bracket
During installation, strictly observe the related operating conditions in "3.5 Special installation (PDP-507CMX)
(pg. 35)".
Caution
When hanging by wires etc., do not add any devices other than the Plasma Display, PDP
bracket, and the optional speakers nor hang it with a single wire, because there is a danger
that excessive load will be applied, damaging the equipment.
Caution
Do not attempt to correct tilt by applying downward load with the wires. Doing so may apply
excessive load upon and damage the wire connections and metal mounting fixture.
Caution
When installing the Plasma Display, do not use the handles as means of hanging the display.
NO!
134
20˚
Wire
Special eye
bolt
Wire
Use the Special eye bolt only at the specified locations.
Improper use of Special eye bolts within the Plasma Display main body may
damage the display's blind nut.
Attach wires to the bolts, as indicated in the figure.
To attach the wires to the ceiling, secure two wires at
two independent points for safety.
• To keep the Plasma Display main body from vibrating,
fix the main body by attaching wire to the bottom bolt.
• Use wires strong enough to withstand a weight of
46.4 kg that is the total of the 35.5 kg of the Plasma
Display, the 4.1 kg of the PDP bracket, and the 3.4 kg
x 2 of the optional speakers.
[507CMX]