Pioneer PDP 427CMX Technical Manual page 231

(When 16 and 25 screen Video Walls)
3
OFF
2 2
MODE2
OFF → MODE1 (after approx. one second)* → MODE2 (after approx. two seconds)*
* The seconds shown above are yardstick targets; errors may occur.
Shift and set the power on timing by grouping OFF, MODE1, and MODE2.
7 Setting the ABL LINK
This option synchronizes the screen brightness on the multiple displays that form a Video Wall.
Apply the AUTO ID function the select a screen divider option (other than OFF).
~ Place the cursor on 'ABL LINK' then press the [2/3]
buttons to change the settings.
Each time a [2/3] button is pressed, the setting changes
as shown below.
3
[Setting the ABL LINK]
ON ........... Brightness of each screen on the video wall is
the same (available for four panel and nine
panel video walls only).
OFF ......... Brightness of the screens depends on the
setting of each display.
[Connecting four displays]
When this option is 'ON', connect the four displays
according to the POSITION sequence numbers in the
figure on the right with the combination cable (Mini-DIN,
6 pin). If the screen division or POSITION has changed,
the ABL link automatically turns off.
Note
• Connect in the same way for a nine panel video wall.
• In case of a 16 or 25 panel video wall, it is recommended that it be used with the power saving setting for the
entire screen changed to MODE1.
The 'VIDEO WALL' settings are common for all inputs.
2
2 2
MODE1
2
3 ON
OFF 2
Integrator Mode
Screen ~
V I D E O WA L L
D I V I D E R
P O S I T I ON
T Y P E
A U T O I D
P . O N D E L AY
A B L L I N K
R E T U R N
SET
COMBINATION
OUT
No.1 No.2
COMBINATION
IN No.4 No.3
COMBINATION
Display 1
COMBINATION
No.1 No.2
COMBINATION
OUT
No.4 No.3
COMBINATION
IN
Display 3
:
O F F
:
N O R M A L
:
O F F
:
O F F
EXIT
MENU
No.1 No.2
COMBINATION
No.4 No.3 OUT
IN
Display 2
OUT
No.1 No.2
COMBINATION
No.4 No.3
IN
Display 4
231