Pip Detect Setting - Pioneer PDP 427CMX Technical Manual

Menu Mode

20) PIP DETECT Setting

During picture-in-picture display, if no subscreen input signal is detected then the black borders of the subscreen are
automatically turned off.
The subscreen mode function is disabled during side-by-side display.
* The lack of a subscreen input signal means there is no video signal or sync signal.
Factory setting: ACTIVE
1 Select 'OPTION'.
2 Place the cursor on 'PIP DETECT' then press the [SET]
button to change the setting.
Each time the [SET] button is pressed, the setting changes
as shown below.
3 ACTIVE
INACTIVE 2
• ACTIVE ...... When no subscreen input signal is input,
no subscreen is displayed. When the
subscreen input is later restored, the
subscreen is displayed again.
• INACTIVE .. When no subscreen signal is input, the
black border is visible.
The 'PIP DETECT' setting is common for all inputs.
212
[Applicable only when a PDA-5003/PDA-5004 is installed]
Screen 2
MENU
PICTURE SCREEN
L A N G UAG E
E N E R G Y S AV E
T I M E R S E T T I N G
S C R E E N M G T.
AU TO S E T U P M O D E
AU TO F U N C T I O N
P I P D E T E C T
S P L I T F R E E Z E
SET CHANGE
INPUT1
SETUP OPTION
: E N G L I S H
: S TA N DA R D
: I N AC T I V E
: O F F
: AC T I V E
: O F F
MENU EXIT