5.3.4 Adjustment and setting in the Menu Mode
1) Power Management Setting
When no video signal (synchronizing signal) is detected, this function automatically sets the energy saving state to
save power.
• To disable the energy saving function, set to [OFF].
• When there is PC signal input:
To switch between the normal-operation state and the energy saving state is depended upon the presence of an
input signal, set 'POWER MANAGEMENT' to [ON].
Factory setting: OFF
1 Select 'SETUP'.
2 Place the cursor over 'POWER MANAGEMENT' and
change the setting with the [SET] button.
Each time the [SET] button is pressed, the setting is
changed as shown below.
3 OFF
ON 2
Note
• To return from the energy saving state (by power management) to the normal operation state, operate the PC or
press the [INPUT] button on the remote control or main-control panel.
However, during SYNC ON G or composite SYNC input, operation does not return by simply operating the personal
computer. After operating the personal computer, press the [INPUT] button.
• The power consumption during power standby.
PDP-507CMX: 0.6 W
PDP-427CMX: 1.2 W
M E N U
P I C T U R E
S C R E E N
S E T U P
P O W E R M G T.
S I G N A L F O R M AT
SET
CHANGE
Menu Mode
I N P U T 1
O P T I O N
: O F F
MENU
EXIT
175