Disassembling The Display Stand; How To Install - Pioneer PDP 427CMX Technical Manual
Plasma display monitor when used with
video cards (expansion solutions cards)
Hide thumbs
Also See for PDP 427CMX:
- Operating instructions manual (164 pages) ,
- Service manual (120 pages) ,
- Reference manual (22 pages)
Table of Contents
Advertisement
[507CMX : 427CMX]
4.9.3 Disassembling the display stand
1 Remove the screws (four locations on the left and right
sides) then take off the bracket. For packing reasons,
the bracket is mounted at a different location then the
final installation location.
Bracket
Screws
4.9.4 How to install
In order to ensure safety during installation, always be sure to work with more than two people.
1 Assemble the unit
Attach the leg base to the display stand using the hexagonal bored bolts (M8 × 60 mm) so that the rear label faces
towards the back casters (shown in the figure below).
Note
For safety, alternately tighten each bolt two times or more until they are firmly fixed in place.
Screws
Label
Display stand
Mobile Cart: PDK-5014
2 Remove the rear cover.
Rear cover
Leg base
Back casters
Support caster
Do not take out the screws.
Loosen the
finger screws.
Washer
Plate spring washer
Hexagonal bored bolts
(M8 × 60 mm)
125
Advertisement
Table of Contents
