Changing The Ha Role - Cisco Nexus 1000V Troubleshooting Manual

Problems with the GUI Upgrade
S e n d d o c u m e n t c o m m e n t s t o n e x u s 1 k - d o c f e e d b a c k @ c i s c o . c o m .

Changing the HA Role

You can use this procedure to change the HA role of the VSM.
BEFORE YOU BEGIN
•
•
DETAILED STEPS
Go to the domain of the existing VSM.
Step 1
configure terminal
svs-domain
domain id domain-id
Example:
n1000v# config t
n1000v(config)# svs-domain
n1000v(config-svs-domain)# domain id 1941
Warning: Config saved but not pushed to vCenter Server due to inactive connection!
Change the HA role.
Step 2
system redundancy role [primary | secondary | standalone]
Example:
n1000v(config-svs-domain)# system redundancy role secondary
Setting will be activated on next reload.
n1000v(config-svs-domain)#
Example:
n1000v(config-svs-domain)# system redundancy role primary
Setting will be activated on next reload.
n1000v(config-svs-domain)#
Step 3 Copy the running configuration to the startup configuration.
copy run start
Example:
n1000v#(config-svs-domain)# copy run start
[########################################] 100%e
n1000v#(config-svs-domain)#
You have completed this procedure. Return to the
Step 4
section on page
Cisco Nexus 1000V Troubleshooting Guide, Release 4.2(1)SV2(2.1)
5-12
You are logged in to the CLI in EXEC mode.
You know the domain ID of the existing VSM.
5-13.
"Recovering a Primary VSM with Active Secondary"
Chapter 5 Upgrade
OL-28795-01