Cisco Nexus 1000V Troubleshooting Manual page 227

Chapter 22 Network Segmentation Manager
S e n d d o c u m e n t c o m m e n t s t o n e x u s 1 k - d o c f e e d b a c k @ c i s c o . c o m .
Table 22-1 Problems with Network Segmentation Manager (continued)
Symptom
The network creation triggered from
vCloud Directors fails. A system
message similar to the following is
logged in the vCloud Director:
Failed to set vmware
port-group
The network creation triggered from
vCloud Directors fails. A system
message similar to the following is
logged in the vCloud Director:
Failed to set state enabled
The network creation triggered from
vCloud Directors fails. A system
message similar to the following is
logged in the vCloud Director:
Failed to collect svs
configuration
The network creation triggered from
vCloud Directors fails. A system
message similar to the following is
logged in the vCloud Director:
Operational status is missing
The network creation triggered from
vCloud Directors fails. A system
message similar to the following is
logged in the vCloud Director:
SVS connection is
disconnected
The network creation triggered from
vCloud Directors fails. A system
message similar to the following is
logged in the vCloud Director:
Failed to create bridge
domain
OL-28795-01
Possible Causes
Unable to set Vmware port group
property on the port profile.
Unable to set the property state on
the port profile to enabled.
Unable to execute the command
show svs connection
Unable to locate the operational
status in the SVS connection.
SVS connection is disconnected.
Unable to create the bridge dmain
associated with the network.
Cisco Nexus 1000V Troubleshooting Guide, Release 4.2(1)SV2(2.1)
Problems with Network Segmentation Manager
Verification and Solution
Check system logs for a port group property
failure message reported by network
segmentation manager. See the Cisco NX-OS
System Messages Reference for more
information.
Check system logs for a state enabled property
failure message reported by network
segmentation manager. See the Cisco NX-OS
System Messages Reference for more
information.
Verify that the Virtual Supervisor Module
(VSM) has an active SVS connection.
show svs connection
When you enter the command, the output must
display
operational status: connected
Verify that the Virtual Supervisor Module
1.
(VSM) has an active SVS connection.
show svs connection
When you enter the command, the output
must display
operational status: connected
Check system logs for a operational status
2.
failure message. See the Cisco NX-OS
System Messages Reference for more
information.
Verify that the Virtual Supervisor Module
(VSM) has an active SVS connection.
show svs connection
When you enter the command, the output must
display
operational status: connected
Verify that the feature Segmentation is enabled.
show feature
If not, enable the segmentation feature.
feature segmentation
22-5