Stopping A Vsm Upgrade - Cisco Nexus 1000V Troubleshooting Manual

Chapter 5 Upgrade
S e n d d o c u m e n t c o m m e n t s t o n e x u s 1 k - d o c f e e d b a c k @ c i s c o . c o m .

Stopping a VSM Upgrade

You can use this procedure to stop a VSM upgrade that is in progress.
BEFORE YOU BEGIN
•
The information in this section does not apply when upgrading from Release 4.2(1)SV1(4) to
Note
Release 4.2(1)SV2(1.1).
DETAILED STEPS
Step 1 Display upgrade status.
show svs upgrade status
Example:
n1000v# show svs upgrade status
Upgrade State: Start
Upgrade mgmt0 ipv4 addr: 1.1.1.1
Upgrade mgmt0 ipv6 addr:
Upgrade control0 ipv4 addr:
Stop the upgrade.
Step 2
configure terminal
no svs upgrade start
Example:
n1000v# configure terminal
n1000v#(config)# no svs upgrade start
WARNING! VSM upgrade process is aborted
n1000v#(config)#
Step 3 Display upgrade status.
show svs upgrade status
Example:
n1000v#(config)# show svs upgrade status
Upgrade State: Abort
Upgrade mgmt0 ipv4 addr:
Upgrade mgmt0 ipv6 addr:
Upgrade control0 ipv4 addr:
You have completed this procedure. Return to the process that pointed you here:
Step 4
•
•
OL-28795-01
You are logged in to the CLI in EXEC mode.
"Recovering a Secondary VSM with Active Primary" section on page 5-8
"Recovering a Primary VSM with Active Secondary" section on page 5-13
Cisco Nexus 1000V Troubleshooting Guide, Release 4.2(1)SV2(2.1)
Problems with the GUI Upgrade
5-9