Cisco Nexus 1000V Troubleshooting Manual page 117

Chapter 8 Ports
S e n d d o c u m e n t c o m m e n t s t o n e x u s 1 k - d o c f e e d b a c k @ c i s c o . c o m .
Example 8-5
n1000v# show port internal event-history interface e1/7
>>>>FSM: <e1/7> has 86 logged transitions<<<<<
1) FSM:<e1/7> Transition at 647054 usecs after Tue Jan
Previous state: [PI_FSM_ST_IF_NOT_INIT]
Triggered event: [PI_FSM_EV_MODULE_INIT_DONE]
Next state: [PI_FSM_ST_IF_INIT_EVAL]
2) FSM:<e1/7> Transition at 647114 usecs after Tue Jan
Previous state: [PI_FSM_ST_IF_INIT_EVAL]
Triggered event: [PI_FSM_EV_IE_ERR_DISABLED_CAP_MISMATCH]
Next state: [PI_FSM_ST_IF_DOWN_STATE]
Example 8-6
n1000v# show logging logfile
. . .
Jan
Jan 4 06:54:24 switch %PORT-5-IF_DOWN_PORT_CHANNEL_MEMBERS_DOWN: Interface port-channel 7
is down (No operational members)
Jan
Jan 4 06:54:56 switch %PORT-5-IF_DOWN_ADMIN_DOWN: Interface e1/7 is down (Admnistratively
down)
Jan
Jan 4 06:55:56 switch%PORT_CHANNEL-5-PORT_ADDED: e1/7 added to port-channel 7
n1000v#
Example 8-7
n1000v# show logging logfile | grep Vethernet3626
2011 Mar 25 10:56:03 n1k-bl %VIM-5-IF_ATTACHED: Interface Vethernet3626
is attached to Network Adapter 8 of gentoo-pxe-520 on port 193 of module
13 with dvport id 6899
2011 Mar 25 11:10:06 n1k-bl %ETHPORT-2-IF_SEQ_ERROR: Error ("Client data
inconsistency") while communicating with component MTS_SAP_ACLMGR for
opcode MTS_OPC_ETHPM_PORT_PRE_CFG (RID_PORT: Vethernet3626)
2011 Mar 25 11:10:06 n1k-bl %ETHPORT-2-IF_DOWN_ERROR_DISABLED: Interface
Vethernet3626 is down (Error disabled. Reason:Client data inconsistency)
Example 8-8
n1000v# show int brief
--------------------------------------------------------------------------------
Port VRF Status IP Address Speed MTU
--------------------------------------------------------------------------------
mgmt0 -- up 172.23.232.141 1000 1500
--------------------------------------------------------------------------------
Ethernet VLAN Type Mode Status Reason Speed Port
Interface Ch #
--------------------------------------------------------------------------------
Eth3/2 1 eth trunk up none 1000(D) --
Eth3/3 1 eth access up none 1000(D) --
n1000v#
Example 8-9
n1000v# show interface e1/14
e1/7 is down (errDisabled)
OL-28795-01
show port internal event-history interface
show logging logfile
4 06:54:04 switch %PORT_CHANNEL-5-CREATED: port-channel 7 created
4 06:54:40 switch %PORT_CHANNEL-5-PORT_ADDED: e1/8 added to port-channel 7
4 06:54:59 switch %PORT_CHANNEL-3-COMPAT_CHECK_FAILURE: speed is not compatible
show logging logfile | grep interface_number
show interface brief
show interface ethernet
1 22:44..
1 22:43..
Cisco Nexus 1000V Troubleshooting Guide, Release 4.2(1)SV2(2.1)
Port Troubleshooting Commands
8-11