Cisco Nexus 1000V Troubleshooting Manual page 14

S e n d d o c u m e n t c o m m e n t s t o n e x u s 1 k - d o c f e e d b a c k @ c i s c o . c o m .
Feature
Recovering Management
and Control Connectivity
of a Host
ACL Logging
NSM
VXLAN
Microsoft NLBUnicast
Mode
In service software
upgrade (ISSU)
VEM software upgrade
DHCP, DAI, IPSG
Virtual Service Domain
Port profiles
Upgrade
VEM health check
VSM connection failure
after ESX reboot
Cisco Nexus 1000V Troubleshooting Guide, Release 4.2(1)SV2(2.1)
xiv
Description
Added new section to recover management
and control connectivity of a host when a
VSM is running on a VEM
Added new section to troubleshoot ACL
Logging.
Added new chapter to troubleshoot the
Network Segmentation Manager (NSM).
Added new chapter to troubleshoot the
Virtual Extensible Local Area Network
(VXLAN).
Added new section for troubleshooting
Microsoft Network Load Balancing
(NLB) Unicast mode
Added new section for troubleshooting
ISSU.
Added new section for troubleshooting
VEM software upgrade.
Added new section for troubleshooting
DHCP, Dynamic ARP Inspection, and IP
Source Guard.
Added new section for troubleshooting
Virtual Service Domain.
Added section for port profiles, new
information about quarantined port
profiles.
Added new section for troubleshooting
upgrade problems.
The VEM health check shows the cause of
a connectivity problem and recommends
next steps in troubleshooting.
The section describes how to prevent loss
of connectivity related to an MTU
mismatch following a reboot of the ESX.
Changed in
release Where Documented
4.2(1)SV1(5.1) "Recovering Management and
Control Connectivity of a Host
when a VSM is Running on a
VEM"
4.2(1)SV1(5.1) "Troubleshooting ACL Logging"
4.2(1)SV1(5.1) "Network Segmentation Manager"
4.2(1)SV1(5.1) "VXLANs"
4.2(1)SV1(5.1) "Layer 2 Switching"
4.2(1)SV1(4a) "Upgrade"
4.2(1)SV1(4a) "Upgrade"
4.2(1)SV1(4) "DHCP, DAI, and IPSG"
4.2(1)SV1(4) "Virtual Service Domain"
4.2(1)SV1(4) "Port Profiles"
4.2(1)SV1(4) "Upgrade"
4.0(4)SV1(3) "Checking Network Connectivity
Between the VSM and the VEM"
4.0(4)SV1(3) "Connection Failure After ESX
Reboot"
New and Changed Information
OL-28795-01