Permanently Setting The Amount Of Water For The Cup Size; Adjusting The Grinder - Jura X8 Instructions For Use Manual

Permanently setting the
amount of water for the
cup size

Adjusting the grinder

CAUTION
It is easy to permanently adjust the amount of water for all single
products to the cup size. Adjust the amount once as shown in the
following example. Every time you prepare a drink in the future, this
amount will be dispensed.
Example: Proceed as follows to permanently set the amount of
water for one coffee.
T Place a cup under the dual spout.
T Press and hold the
Press button'
T Release the 'Coffee'
Preparation starts and the coffee flows into the cup.
T Press any button except
coffee in the cup.
Preparation stops.
set amount of water for one coffee is permanently stored.
Your X8 is once more ready for use.
E You can alter this setting at any time by repeating the above
procedure.
E You can also permanently set the amounts for all single
products in programming mode (see Chapter 4 'Permanent
settings in programming mode – Adjusting the product
settings').
You can adjust the grinder to suit the degree of roast of your coffee.
If you adjust the consistency of grind when the grinder is not oper-
ating, the grinder adjustment wheel could be damaged.
T Only adjust the consistency of grind when the grinder is run-
ning.
The consistency of grind is correct if the coffee flows regularly from
the coffee spout. In addition a fine, thick crema forms.
You can set the consistency of grind using the spanner provided.
Example: Proceed as follows to change the consistency of grind dur-
ing the preparation of an espresso.
T Place a cup under the dual spout.
T Open the cover behind the bean container.
'Coffee' button until
appears.
button.
'Cancel' as soon as there is sufficient
'Saved' appears briefly on the display. The
2 Preparation
'Enough coffee?
17